| DX Gaming http://www.dxgaming.com/forums/ |
|
| blacksmithing master craft http://www.dxgaming.com/forums/viewtopic.php?t=22929 |
Page 1 of 1 |
| Author: | Falin [ Sat Jun 18, 2011 4:36 am ] |
| Post subject: | blacksmithing master craft |
i know its supposed to be harder, but i was making 20 valo chest plates to train with and im at 99.3. i watched it say "you work with the skill of a master" 8 out of the ten times it said how well i did, for a peice and it went expert only. out of 20 none were master peices. seems darn near impossible? can you tell us what percent we should be making in your eyes ? so that we can judge if its messed up or not? doenst seem like it should be that hard. if valo is that bad at 90 difficulty, then blood would never happen at 99 difficulty. |
|
| Author: | GMBob [ Wed Jun 22, 2011 3:07 am ] |
| Post subject: | Re: blacksmithing master craft |
Your other two hits must have completely sucked. Since strikes are cumulative, and any strike that registers master is actually 10 points over the master limit, you woulda had to have those two strikes be a combined 80 points below master, if we assume your earlier strikes were just barely above. That being said, yeah since i increased the work each resource needs to craft it into something (which gives you all more gains per used resource, at the cost of time), the strikes required per item went a little higher than i originally intended with the formula. I gave it a little balance, but for the most part master should be rare. How many of those valorite were normal and how many were expert? |
|
| Author: | Falin [ Wed Jun 22, 2011 3:06 pm ] |
| Post subject: | Re: blacksmithing master craft |
they were all expert.....can you tell us the diff between regular, expert and master? if there even is one? |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|